Home > Blue Screen > BSOD New SSD Fresh Install

BSOD New SSD Fresh Install

Contents

Installation & Setup Clean Install of Win7 - Wipe Hard Drive CleanHi Folks, I just did a clean install of Win7 and must have done something wrong. Resume testing. So overnight, I ran Snapshot's restore utility again. Some said that iaStor.sys was the driver for Intel Matrix Storage Manager which needed to be updated. have a peek here

I'm always surprised by the people here who have obvious heat issues but refuse to believe it, this thread being one of the mildest cases. At this point I wondered if I tried restoring my own image of my C: drive which I'd made using Snapshot, while leaving the System Reserved partition in place, whether magic Ask a new question Read More Configuration Privacy SSD Blue Screen Windows 7 Related Resources solved fresh windows 7 install vs. My CPU barely hits 50C during stress testing, and idles in the 30s.To confirm, what do you mean by "general use?" Just web browsing? http://www.tomshardware.com/forum/40523-63-bsod-fresh-install-windows

Ssd Causes Blue Screen

And at the time of writing this, nearly a week after the successful installation, no Blue Screens of Death. I'm planning to do a clean install of Home Premium x64 today or tomorrow. It's a pleasure to use it again. I came very close to giving up, but I'm glad I persevered.

  1. The 100 MB partition is created by Windows during OS installation.
  2. With now everything set up as much as the BIOS allows me to enable Secure Boot, I Exit and Save.
  3. NU Star BSOD, App Crashes And Hangs 10 03-11-2011 07:07 AM [SOLVED] CHKDSK /R on Kingston SSD Causes BSOD I just installed a Kingston 128GB VNow SSD in my brand new
  4. Hopefully that'll mark the end of my problems.
  5. Message 4 of 14 (17,198 Views) Reply 0 Kudos 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 damienoh Newbie Posts: 2 Registered: ‎05-29-2012 Re: Bluescreen when installing Win7 in
  6. This is not my video, but it shows very well the speed differences for booting and shutting down.
  7. Others talked about doing a Startup Repair Some of the forums said that the fault was caused by the TDSS Rootkit, which could be removed using Kapersky's TDSSKiller utility For me,
  8. PROBLEM 2: Impossible to Boot Windows 10 Recovery Disk So after losing hope, I decided to at least get Windows 10 installed on the SSD.

Remove Gigabyte ET6 and Smart6, they are known trouble makers as well. I ran the same setup minus the SSD before and never had any errors. I closed the back of the case, turned over the laptop and pressed the Power button. Stop: 0x0000007a He seemed knowledgeable and got to work trying to make my computer boot.

Once I even was able to log in to desktop (took ~5 seconds) before it happened. The computer restarts and seems to be booting the USB stick but immediately returns the following error message. My system is not fully setup yet, so I can reproduce the issue if needed. https://answers.microsoft.com/en-us/windows/forum/all/bsod-issues-after-installing-ssd/542b7fc3-67b2-4188-90a8-2a06f6b8973a Articles & News Forum Graphics & Displays CPU Components Motherboards Games Storage Overclocking Tutorials All categories Chart For IT Pros Get IT Center Brands Tutorials Other sites Tom's Guide Tom's

Lured by the promise of stunning performance and amazingly fast boot times, I spent the four times the cost of a normal 500 gigabyte hard drive on a Solid State Drive Samsung 850 Evo Blue Screen Using Rufus, I created a bootable USB stick formatted as Fat32 and partitioned as GPT since my Bios defaults to UEFI. Format HDD - Format HDD - sysnative.com - MVP Did you have BSODs when running system on HDD or did they first appear after SSD introduced? jcgriff2 ` BSOD SUMMARY Code: Loading Dump File [C:\Users\PalmDesert\_jcgriff2_\dbug\__Kernel__\012412-5631-01.dmp] Built by: 7601.17640.amd64fre.win7sp1_gdr.110622-1506 Debug session time: Tue Jan 24 22:22:59.982 2012 (GMT-5) System Uptime: 0 days 0:00:02.215 Probably caused by : ntkrnlmp.exe

Ssd Bsod Windows 10

Installation & Setup Clean install onto new driveI just wanted to get some confirmation on my procedure. permalinkembedsaveparentgive gold[–]manirelli 0 points1 point2 points 5 years ago(0 children)Glad to see you got everything working. Ssd Causes Blue Screen You will need to test each stick independently in each DIMM slot. Samsung Ssd Bsod I found prior thread - [SOLVED] BSOD errors help __________________ BSOD Posting Instructions - Windows 10, 8.1, 8, 7, Vista `` ` `Driver Reference Table (DRT) jcgriff2 BSODs ▫ Hex Date

Attached Files perfomon.zip (149.0 KB, 13 views) Windows7_Vista_jcgriff2.zip (564.5 KB, 17 views) 012412-5631-01.zip (14.0 KB, 19 views) Remove Advertisements Sponsored Links TechSupportForum.com Advertisement 01-24-2012, 11:30 PM #2 jcgriff2 navigate here My intention was to pull the original HDD out and do a clean install of Windows 7 on the SSD. worked with the support team they had me switch the BIOSSATA operation setting from AHCI to ATA.I re-installed Windows and I'm up and running. you can search for HDD erase and use that to secure erase the drive. Ssd Blue Screen On Boot

So I tried it again. Copying the Existing Drive to the New SSD The Samsung SSD even came with software utility to clone the existing drive to the new SSD. In IDE mode I got 7.6 and in AHCI mode 7.8 (max being 7.9). http://howtoblog.org/blue-screen/bsod-during-xp-install.html However, the most recent BSOD occurrence happened when the computer was idle.

I have verified that the SATA AHCI mode is enabled in the BIOS for this device. Intel Sata Controller Specs are: *Win7 x64 *OEM original install from vendor *system purchased only 6 mo. Now when the computer goes to sleep by itself and I start it up again, I'm presented with the same F4 0x00...03 BSOD every time.

R201 firmware is loaded on the SSD.

BuildAPC Beginner's Guide Chat on our IRC channel Daily Simple Questions threads Please keep in mind that we are here to help you build a computer, not to build it for My BIOS is version N78 Ver. 1.06 12/18/2015. Nothing works. Blue Screen After Cloning Ssd I have 8gigs of 1600 Ram.

It appears that the BSOD happens as device initialization phase, as the HDD led flashes once per second and in IDE mode my screens get swapped that does not happen in Thank you all in advance. This is my motherboard:GIGABYTE GA-Z87MX-D3H LGA 1150 Intel Z87 HDMI SATA 6Gb/s USB 3.0 Micro ATX Intel MotherboardAnd yes I have used the magician to optimize the SSD. this contact form First Experience with the SSD - invalid operating system on board.

I just installed a fresh copy of Windows on a new SSD. I haven't had many issues with this hardware before, but now it's becoming borderline unbearable. Might be a problem with that line of drives that's already been fixed by the manufacturer. I chose the Samsung SSD 840 Series drive with a capacity of 500 gigabytes.

foscooterApr 12, 2012, 12:54 AM With that motherboard (which I have in my wifes PC), it is NOT SATA III.But the drive should scale down to SATA II. solved Blue screen of death problems solved Blue Screen of Death problems after install drivers solved Blue Screen of Death after new install of OS on new SSD solved New RAM Another notable thingy is that when Win7 boots up, the "flying lights" do not get to form the Windows logo before I'm requested for account password. This was like 2 days ago, and I had to do a clean install with BIOS set to IDE.

Ask a new question Read More SSD Blue Screen Computers Storage Memory Related Resources solved Blue Screen Problems Blue screen after fresh instill window 7 ssd solved Still frozen Samsung ssd Everything seemed to work well. solved Fresh windows install on new SSD solved How to transfer windows 7 from and old hdd to and ssd with a fresh install? I always get the same Secure Boot error message and disabling Secure Boot never saves.

Tekken Back to top #5 Pauru Pauru Topic Starter Members 6 posts OFFLINE Local time:07:13 AM Posted 05 September 2013 - 11:29 PM Did you happen to download the Tom's Hardware Around the World Tom's Hardware Around the World Denmark Norway Finland Russia France Turkey Germany UK Italy USA Subscribe to Tom's Hardware Search the site Ok About Tom's Hardware This is occuring on both a DELL Latitude E6410 and E6400 laptop.I have verified that the SATA AHCI mode is enabled in the BIOS for this device.R201 firmware is loaded on It does recognize the DVD and lists it properly if I go to the boot menu.

I started her up tonight and got a PFN_LIST_ERROR BSOD. solution SolvedDell Inspiron Can't Boot Windows Vista After Fresh Install solution Solvedfresh install of windows 7 on a gateway ne56r41u laptop, missing drivers for network adapter solution SolvedFresh windows 8 install We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.